Description

Descriptions WF96HT- digital display temperature and humidity controller，temperature detection, heating or cooling control, high or low temperature alarms can be realized through APP or instrument buttons. The product is suitable for various commercial and industrial occasions.Such as Heating System，Hot Water System，Boiler, Breeding, Hatching，and cooling control of intelligent electromechanical equipment. Functions Remote switch control, real-time temperature feedback. Can run independently without WiFi，stand-alone temperature control. The thermostat can be turned on or off manually no matter where you are. Dual output, temperature control and humidity control, automatic selection of high on and low off or low on and high off according to the set parameters. Account sharing function. Parameter Setting NOTE: Recently the chip has been updated, networking more convenient, after the power supply directly in accordance with the steps shown in the picture can be operated without the need to long press the start button, if the network fails, please try to follow the steps below. * Long press the "Start " button to enter the Start Temperature Parameter Setting ，display the start temperature value and flashing. press the " Start " or "Stop" button to adjust the value（Long press to quickly add and subtract）If there is no operation after setting, it will automatically return to the operation page after three seconds. * Long press the "Stop " button to enter the Stop Temperature Parameter Setting ，display the stop temperature value and flashing.press the "Start" or "Stop" button to adjust the value（Long press to quickly add and subtract）If there is no operation after setting, it will automatically return to the operation page after three seconds. Manual Temperature Control Manually Open：When the temperature control has no output, the stop temperature is not reached,press "Stop"button,Manually turn on temperature control output,Once the stop temperature is reached, the relay will open. Manually Close:When the temperature control is outputing, but the stop temperature is not reached,press "Start"button,Manually turn off temperature control output,Once the start temperature is reached, the relay will The relay will close. Note: Output 1-the left button is manual switch Output 2-the right button is manual switch Under output 2 is in the high-on low-on working mode , the manual switch is invalid WiFi Connection * When the power is turned on for the first time after wiring, the product enters the WiFi configuration mode by default. * If the product has been added to the app，when you need to reconfigure,Keep pressing the start button before powering on, and then power on again,release the button until the Indicator light1and 2 are flashes on the screen,entered the WiFi configuration mode this time. Note: After the user set the controller on APP, the device itself will keep the record, even the wifi is disconnected, the device can also keep working according to its memory.